Tell us about yourself!
Reversing a Motor
Large Motors Class
Intro to Fusion 360 UI
Sketch the Lamp
3D Design Class
Introduction to Fusion 360: Design a Lamp in an Hour
Penolopy could you tell me where I went wrong. I want to make sure I don't make the same mistake in the future.
even I have the same doubt. I was also wondering where I went wrong.
Statue of Liberty BoseView Instructable »
Iron Man BoseView Instructable »
Fenrir: an Open Source Dog Robot
QUATTRO - the Arduino Quadruped Robot
simple, low cost, compact, open source extruder. ATOM 3D Printers