214,6033
PhD Candidate at ETRO (VUB) in Brussels, Belgium.
StevenVB's instructable
Achievements
1+
Featured Instructable
Earned a bronze medal
- StevenVB commented on StevenVB's instructable DIY HEPA Air Purifier (Lasercut + 3D-print)2 years ago
- StevenVB entered DIY HEPA Air Purifier (Lasercut + 3D-print) in the Invention Challenge 2017 contest 2 years ago
- StevenVB favorited Huge POV Display by ThomasVDD2 years ago
- StevenVB's instructable DIY HEPA Air Purifier (Lasercut + 3D-print)'s weekly stats: 2 years ago
1,119 views21 favorites2 comments
- StevenVB commented on StevenVB's instructable DIY HEPA Air Purifier (Lasercut + 3D-print)2 years agoView Instructable »
Thank you! For your application I would advice to add a thin layer of active carbon just strapped around the filter with a rubber band. This would help with smells :)
- StevenVB posted an instructable DIY HEPA Air Purifier (Lasercut + 3D-print)2 years ago
- StevenVB made the instructable OPEN SOURCE AIR PURIFIER2 years ago
Hey ad5000,Stacking two identical fans will just result in an increase in static pressure, but pretty much won't increase peak air flow. I would definetly recommend using the largest possible, as these often come with higher CFM and produce much less noise. Good luck!Steven