author
1Comments

Tell us about yourself!

  • ZabakK commented on randofo's instructable Hacking a USB Keyboard4 years ago
    Hacking a USB Keyboard

    I've done this independently couple of times. Here are some tricks: Use soft wire to solder it to the board and after soldering it to the pins, use hot glue to secure it in place.The tracing of the sheet lines can be difficult and boring and prone to errors, most keyboards usually split the pins into two A and B section where the pin from A part connect to the one of the pin in B section so I just plug the USB, fire up a keyboard to screen app and then use wire to shorten pin from A section with pins from B section one by one then note the corresponding ASCII on paper.

    View Instructable »