author
8Comments

Tell us about yourself!

Complete Your Profile
  • Nunchuk Controlled Robotic Arm (with Arduino)

    Ok. I ordered a power source that will work, should come in a bit. For now, when i look at serial monitors and press both buttons at 9600 kbps, and.... nothing changes.... baud is kbps right? I couldnt find anything that changed....

    In the code you provided and diagrams you showed, are you sure that which servos go to which ports are matched up? I look on the shield and it looks sort of different..

    I think you were right and i put each servo with reverse pins in code. But when I tried it and... nothing. Still says gripper is open. I switched the code back to how it originally was

    View Instructable »
  • Nunchuk Controlled Robotic Arm (with Arduino)

    Ok, none of the serial port is affected by nunchuck.... i think i need a power supply for that to work? The code now uploads, just nothing else works... should i connect power source while it is connected to computer?

    Ok, all the libraries are in, everything is set up good. I hit upload, it says succesful, but nothing moves or happens. I am using the original nunchuck with the shield. Do you know what might be going wrong.

    Also, none of the motors have so much as moved the tiniest bit no matter what i try...

    View Instructable »
  • Nunchuk Controlled Robotic Arm (with Arduino)

    Hi! I got to the adding library stage, and i cannot get the library to work. Would the wiichuck library also work?

    View Instructable »