cornelius3's instructables

Achievements

10K+ Views Earned a bronze medal

cornelius3 commented on cornelius3's instructable Laser Engraving Powder Coating
Sorry. I don't have a suitable answer for you on that. We used a Trotec CO2 laser. Any laser engraving setup should work since you are burning off the powder coat and exposing the raw metal again. I would run tests on scrap coated pieces to figure out speed and intensity. Then apply the same settings to my final pieces.
View Instructable »
cornelius3 favorited Power LED's - Simplest Light With Constant-current Circuit by dan
- Power LED's - Simplest Light With Constant-current Circuit
  View Instructable »
cornelius3 commented on callmeappytechie's instructable Control Servo Using PIR Sensor
What code?
Looks great until you realize there's no code. Very annoying.
View Instructable »