Tell us about yourself!

Complete Your Profile
  • ehurtubise commented on misan's instructable 4xiDraw5 months ago
    4xiDraw

    Hello, How or what did you remove from the files, that resolved the M80 error that occurred. i believe i fixed the other issue thanks to your steps further down in the forum, however i still get the M80 error. Thanks

    View Instructable »
  • ehurtubise commented on misan's instructable 4xiDraw5 months ago
    4xiDraw

    Hello,I followed the steps to use the Torsten extensions. However when i go in inkscape and go to extensions axidraw control and go to click apply this message shows up.Traceback (most recent call last): File "axidraw.py", line 43, in <module> import ebb_serial# Requires v 0.9 in plotink: https://github.com/evil-mad/plotink File "C:\Program Files\Inkscape\share\extensions\ebb_serial.py", line 37, in <module> from plot_utils_import import from_ink_extensions_import File "C:\Program Files\Inkscape\share\extensions\plot_utils_import.py", line 1, in <module> from importlib import import_moduleImportError: No module named importlibCan anyone help me? I not sure what this means. Thanks

    Hello,How do you Get the GRBL out of alarm state? This keeps poping up as i try to send the code from the universial g-code sender to the arduino board.

    View Instructable »
  • ehurtubise commented on misan's instructable 4xiDraw5 months ago
    4xiDraw

    I installed the torsten way however i'm getting "Failed to connect to 4xidraw error". Even after use the following GRBL setup that is located in the link you provided. Is there any other solutions that you can provide for me. Thank You

    View Instructable »
  • ehurtubise commented on misan's instructable 4xiDraw5 months ago
    4xiDraw

    Hello, i was just wondering how you solved the M80 command. in having the same issue and i'm unsure of what to do.Thanks

    View Instructable »
  • ehurtubise commented on misan's instructable 4xiDraw5 months ago
    4xiDraw

    This message popped up when I sent the file through the g-code sender.An error was detected while sending 'M80': error. unsupported command. Streaming has been paused.What does this message mean?Thanks

    View Instructable »
  • ehurtubise commented on misan's instructable 4xiDraw5 months ago
    4xiDraw

    Should i be putting all the python files in the folder on the main c drive?

    I'm new to this programming stuff, this is for a class project and i'm kind of lost. i have attempted the torsten plugin however i'm not sure about how to install the pyserial. Also when you say rename python in inkscape to python-old, this file is located in the library of the inkscape document, correct. Thanks for the help.

    View Instructable »
  • ehurtubise commented on misan's instructable 4xiDraw5 months ago
    4xiDraw

    Hello,I just finished going through the code and redoing the python step becuase it didn't work the first time. After getting it all loaded i go into inkscape and try to export the file and i get Could not find platform independent libraries <prefix>Could not find platform dependent libraries <exec_prefix>Consider setting $PYTHONHOME to <prefix>[:<exec_prefix>]what does this mean? what should i do?

    View Instructable »