exblaze's instructables
Tell us about yourself!
Achievements
10K+
Views
Earned a bronze medal
- exblaze completed the lessons Welcome to Arduino and Tools and Materials for Arduino in the class Arduino Class
- exblaze enrolled in Arduino Class
- exblaze completed the lesson Casting Unusual Shapes in the class Concrete Class
- exblaze commented on mikeasaurus's instructable Casting Molds With Voids
- exblaze completed the lesson Casting Molds With Voids in the class Concrete Class
- exblaze made the instructable Casting Molds With VoidsView Instructable »
ausing a DIY vacuum former and a shop vac I created two molds. One of a rubber duck and a lid to a spray paint can. Had to dremel the duck out od the mold. It proceded to self destruct. I will try again. The lid turned out good but the side fell out. Lesson= go slow whe taking cement out of the molds
- exblaze completed the lessons Casting In Pre-made Molds and Mixing + Pouring Concrete in the class Concrete Class
- exblaze enrolled in Concrete Class
I believe the Duck was way over watered. The cup on the other hand was not as over watered. Once I get my vacuum former back (tomorrow) I will redo the mold then put some more cement in it.