Tell us about yourself!
This is a great idea!I have a question though. Would it be possible to make the Solenoids behave differently depending on the type or data of a MIDI message, such as tapping for a "Start" & holding for a short amount of time for a "Stop", or adjusting the force applied depending on Note Velocity?
MIDI-Controlled 88 Key Reed Organ With MIDI-Over-Bluetooth
How to Make a Tesla Coil
Simple Grafting Without Special Tools
Battery Capacity Tester
Extend Defective Fluorescent Tube-Light Life
DIY Laser Diode Driver || Constant Current Source
Homemade PCB Etching (through Hole Parts)
The Plasma Speaker
But can it be used to take over the world?
How to Make a Raspberry Pie With a Raspberry Pi
Floppy Drive Music /w Raspberry Pi
Finally! A way to make these using a Raspberry Pi! Time do dominate the world with musical data storage!
Arduino PCR (thermal Cycler) for Under $85
Build Your Own Development Board
If it's a very small screw, put a drop of Cyanoacrylate glue on the end of your Jeweler's Screwdriver, put the end in the screw, then carefully put Water over the glue, the Cyanoacrylate reacts with Water & hardens much faster, once the glue is completely hardened, turn the Screwdriver & remove the screw, you can use sand paper or a nail file to remove the glue from the Screwdriver.For larger screws & bolts, you can use something like JB Weld or you can even solder the Screwdriver to the screw, sandpaper with remove the JB Weld, the solder should just break off unless it completely adheres to the Screwdriver, if it does, you can scrape it off.
Ok, thank you.
I can't tell the orientation of the Chip on the schematic. Could you help me with that?
Could I do this using a Raspberry Pi instead of an Arduino?