Tell us about yourself!
I tried this out but the buzzer just buzzes like crazy all the time. Any Solutions?
Hello, I don't have a 10nF cap anywhere...If I want to use a 100nF cap, are there any adjustments needed to be made? I Used your code but no led light up.
By the way, RX led is flashing which means it's receiving info over the serial port. What should I do?
I tried this project with a slightly modified code that was copied from A Kerbal Player's Guide and I made this project. This is what happens:I load the vessel onto launchpadWhen it is loading, The handshake LED lights up for 2 seconds, then fades out.Not a bit a signal after thatThe second launch, absolutely no lightsSame with all the launches that followAfter I reset the Arduino and bring the vessel to the pad, steps 2-5 repeat.Why does this happen? Any comments and suggestions will be welcome!
I found something interesting about the module. If you attach a motor to a switch (VCC --> button--> motor --> GND) so that the motor spins when you press the button, whenever you push the button the seven segment resets. It really isn't a bug, but what might be causing this?