jscottb's instructables
Tell us about yourself!
Complete Your ProfileAchievements
10K+
Views
Earned a bronze medal
1+
Featured Instructable
Earned a bronze medal
- jscottb commented on jscottb's instructable Simple Multi-mode 4wd Rover JR-001 2 months ago
- jscottb commented on jscottb's instructable Simple Multi-mode 4wd Rover JR-001 2 months ago
View Instructable »The second board is an Arduino V4 sensor shield.
- jscottb commented on jscottb's instructable Simple Object avoider robot the using Actobotics Runt Rover Peewee chassis and a Arduino1 year agoView Instructable »
Hi,I would check the motor wiring, you may have one side backwards. You could try switching one sides motor wires and see if that changes anything.
- jscottb commented on jscottb's instructable Simple multi-mode 4wd Rover JR-001 2 years agoView Instructable »
Sure. Any standard size servo should work.
- jscottb favorited DIY MOSFET Motor Controller by zeropt2 years ago
- jscottb favorited CNC Robot Plotter by lingib2 years ago
That's a small breadboard used to connect the grounds together for all of the boards and power. I did have a larger one on the bot at first then changed to the smaller one later. Bother were black.