Tell us about yourself!
Had to make one, for the memories :) Added some leds too, always need some leds. but the audio was very quiet/low volume so i added an upgrade port for a lm386 amp. its detachable so i can use it for other projects too. great instructable thanks!
Great instructable, works nicely and easy to make for a newbie like me. thanks alot!
Made it. hopefully works too :) Wasnt sure how to connect the servo. one motor is out of the picture when the servo is in use so maybe power from motor and third cable for data to the header pins? Iam not good at this. But great instructable, thanks alot!
Made it. Relay works but the led doesnt light up. Iam not sure about my knowledge of schematics so i just put the led plus to +5v and the minus between relay minus and the 547b, resistor is there too. dont know if its correct though. but great instructable thanks!
Made it and it works First chip programmed :) great instructable, thanks!
Made it! Fun little project, got me to know some attiny stuff and do more with them. Great instructable, thanks!
Nice little power source and good instructable. I even got it working on the first try :) Thanks alot!
Thanks for this. good instructable! Made it but didnt work :) I have all the components in the right places and right polarity and all the jump wires should be in the right places but the led doesnt light up and the 7805 gets really hot in a second.theres some errors in the pic about the bottom jumper wires as stated but is the paper pic about the bottom wires still correct? And also i tried the board with 1Kohm resistor as was in the parts list but changed it to 10Kohm but still didnt work. Any ideas? Iam not an electrician so dunno about these that much :)