martinhui

Can you have a schematic drawing on the driver?

Not very good idea, single wheel cart doesn't move on decline slope, but you may have!

I've seen this in a Japanese temple, it doesn't sound but guide the water from the canopy, the day was a rainny day.

if you're using android phone, there is already an app called Spykit doing the same, no coding needed.

I used a discharger not known the discharge resistance, the values shown to discharge 1A current from 4.20V to 3.0V took 23 min 17 sec, can you calculate the mAH?

oh sorry, where is your schmatic?

I have searched many site found repeating these wording: "Before using new nRF24L01 modules,we shall burn the modules by uploading default sketch pingpair and GettingStarted for tuning up frequency otherwise it will has uncommunication problem", can you advise how to do that?

not funny, if you want go to this link: http://163.30.123.244/camel/images/arduino/arduino...but chrome report it dangerous, go on your own risk!

may I check with you that your code is written for common anode display? how to change to common cathode display, I have done a similar code but only work for common anode, now I brought common cathode cannot work

WOW! DISGUSTING!!!!!!!

uncontrollable is not power!

為什麼沒有VIDEO，希望知道你如何動....................

The hongkongese would boil coke with gingers to heal cold and flu, try it at home.

I tried below workableadd a push button as reset between CHPD and GNDadd an one post switch between GND and GPIO0add a pull up resistor between VCC and CHPD1. grounded GPIO0 by flipping on the switch 2. push reset button once3. download file and release GPIO0 afterward

Thanks for your watch, but I made a minor mistake, the data type of second must correct to static unsigned long second = 0; because int type cannot accommodate 86400.

Thanks VM