Tell us about yourself!
If the objective is to produce something and a person doesn't reach that objective, something went wrong. Why is everyone so touchy with words nowadays?
If you changed the orientation of the wall material so that the channels ran vertically, instead on horizontally, you could cut finger joints in the corresponding corners and use a segment of stiff wire inserted in the overlapping channel to be the hinge. Just pull the wires to knock it back down to 4 individual wall sections and it would truly be flat packed.Nice job with this instructable.
Wouldn’t a usb to serial cable work for this?
I have this exact model. It also has a 6" riser block installed. I acquired it in working condition about 20 years ago for $100 along with an Atlas floor standing drill press, also for $100. Both were owned by a machinist The bandsaw needs new tires. Where did you source yours?
I believe Dark Solar means polyurethane when 'poly' is mentioned.
You just need to keep in mind that all of those screw heads are now conducting electricity and he mindful of shorting between them.
Couldn't you use the deck to true the drum. Attach sandpaper to the deck and use your adjustment knobs to raise the deck into the spinning drum. You'd have to go slow, but unless the drum is way out of round, this method should work.
It turned out beautiful. Amazing what can be done with plain old construction lumber.
He wanted to create a thicker work surface so he split the 2 x 6 down the middle to give him 2 piece that are nominally 1 1/2" x 2 5/8" roughly. Once he laminated them, he had a 2 5/8" thick work surface
he split the 2 x 6 to give him a nominal 1 /12 x 2 5/8 that he laminated to give him a 2 5/8" thick worksurface
I've seen torsion box tables made in Wood magazine for use as an assembly table. They are very flat and light, for their size. Here's a link to an instructable that shows torsion box construction for shelves, but can easily be scaled up to make a table top.https://www.instructables.com/id/The-Versatile-Torsion-Box/
Does the heated HDPE give off any fumes or odor while it's heating? Just wondering if the e will have an issue if I try this in her oven.