Tell us about yourself!
The Legacy machines have a vertical axis that con be used for longer side pieces.
Simple Yet Strong Clamp Rack
Inexpensive Garage Lights From LED Strips
DIY AUTOMATIC SOLAR CHARGE CONTROLLER
This is a good project and well done.A note on batteries: There is a point where cell voltage is critical (the lower limit) and any further discharging will cause cell damage- on a acid based battery it is around 1.8 volts per cell (2.17 Volts nominal voltage per cell) . To prevent damage you should install an automatic battery disconnect to protect the batteries. Find the lower limit (point of damage) from the battery manufacturer and use this to cut off the batteries so they will last longer.This sounds like a great DIY project that is not difficult and may be integrated with this project!Great job!Randy O'Laughlin - former Telco battery tender...
Making Half Blind Dovetail Drawers for a Walnut Desk
Arduino Wireless Weather Station
Getting Started with Autodesk Fusion 360
Ultra Low Cost 3D Scanner
Build your own cnc machine
Mini CNC Plotter - Arduino Based
How to "Weld" Aluminum Without a Welder
Watering Garden with GARD-A-WATER Arduino Project
Using the LM335 Temperature Sensor
Arduino Auto Watering Garden Project
WATERING SYSTEM - INTRODUCTION
Arduino Temp/Humidity with LCD and Web Interface
Arduino Quilting Machine
3DPrintMi - Assembly Guide
DIY CNC Router