Tell us about yourself!
Active Air Filter (HEPA 13 Filter and Active Carbon Pellets)
Knife Sharpening Angle Coach With Bluetooth & Arduino
Interesting article. When I had to replace a end stop wire on my 3d printer and add a JST connector I first bought an IWISS crimper (https://www.amazon.com/gp/product/B00OMM4YUY/). I could be wrong, but my estimation at the time was that it just wasn't sized properly for what I was trying to crimp. There are two different sized sections - one to crimp around the insulation and one around the wire - but the one on the wire side was too wide causing the pin sleeve to be crushed. I found the PA-20 crimper from Engineer Inc. (https://www.amazon.com/gp/product/B002AVVO7U) that only crimps one part (insulation or wire) at a time. I think that simplifies the issue greatly.
3D Printed Lathe
3D Printing Class