Tell us about yourself!
on average how many bombs does this make based on the size sphere you used?
How to Store 3D Printing Filament
The Aperture Science Sentry Turret With an Arduino
POV Arduino Fidget Spinner
Designing Fidget Spinners in Fusion 360
How to Use Onshape and Assembly
How to Control a 3D Printer With a Phone Via DIY AstroBox
DIY Delta 3D Printer Using Low Cost Recycled Parts
3D Home Printer With Arduino
LEGO 3d Printer
How to Mod a Computer Case
Arduino Drone | Quadcopter (3D Printed)
Phone Controlled Computer Starter
Wireless Power Transmission
Would it pretty much be the same setup if I used a 5v charger say for like a phone and connected to other end a 5v LiPo batter charger with a 3.7v LiPo 650mah
brilliant thank you ive already been working on some stuff but terrible with code thank you again for the instructable
Odd it still seems to not want to take at commands though
Silly me I dropped the ball majorly there, I forgot to disconnect GPIO0 from ground and run it after the reset. Thank you works well, wonderful tutorial
Tried doing this but it wont send back AT commands so i tried uploading the code anyways and it seemed to work but when it tries to connect and i watch it in serial monitor i get what i pasted below and nothing moreany thoughts?Connecting to ASUS..............................
Raspberry Pi Water Cooler
DIY Filament Extruder
AC heated bed Sunhokey Prusa I3
Build your own 3d printer filament factory (Filament Extruder)
AMPLFY Mini DIY Portable Speaker - Solar / Bluetooth / Flash Light / Phone Charger
Recycle Your Dead Old Laptop Battery
Convert Your Old Laptop Battery Into a Power Bank
what kind of batteries are those, it's a dead link, is there a way to add more batteries for greater life?
The 3DPrinted "Furry Vase"
Replicating body parts in plaster
DIY Solar Panel
Noodle: a crowdsourced robot
Raspberry Pi Projects
The Useless Box
also you state there are 3d printed parts in this?
do you have a pattern for the frame that can be done by hand other than laser cutting it
EWaste 60$ 3DPrinter
Super Cheap 3D Printer from CD-Rom Drives
Poor Man's 3D Printer
DIY a Raspberry Game - 2048
LCD 3D Printer
Works really well except when it gets cold it seems to become 100% worthless like rewarming it did nothing, have to swish it around a lot until I get a air pump. Would a coffee warming plate be a bad idea to try and rewarm it with?
Curiosity 120$ eWaste Educational 3D Printer
attempted with amd socket am3 phenom 2, 5v meter says .8 amp won't get warm lol wonder if it's not getting enough juice