Micro Rc Heli to Rc Plane
Intro: Micro Rc Heli to Rc Plane
This is how i made a old micro rc heli into a flying 2 channel rc plane.
ALL up cost about $4 nz as i allready had a micro rc heli.
ALL up cost about $4 nz as i allready had a micro rc heli.
STEP 1: What You Need
A 3 channel micro rc helicopter like the one below.
A $2.00 ruber band powered foam plane.
A hot glue gun.
A $2.00 ruber band powered foam plane.
A hot glue gun.
STEP 2: Step 1
Get your ruber band powered plane and asemble it but with out the rubber band or the propeler.
STEP 3: Step 2
pull apart rc helicopter.
STEP 4: Step 3
atatching all parts together. just follow the video its simple just hot glue everything on.
STEP 5: Finished
ok now you have a finished IR rc plane made for about $4 the range isn't that far and it depends on how you set the board on the plane as to how much range you get.
14 Comments
22alexander 8 years ago
expertman 8 years ago
show us the video of the plane flying
and how much did it weigh and the thrust of the motor
Timofte Andrei 9 years ago
show us the thing flying!
dil2abu 9 years ago
remzak 9 years ago
Differential thrust.
Soundshock 10 years ago
dlane7 10 years ago
dil2abu 9 years ago
any suggestions for the propellers?
does it flies well?
_-_I_-_ 10 years ago
You also have to add a few ressistors for protecting the mosfet/transistor.
Secundairy ciruit from the transistor you can connect with other batteries and other dc motors.
Easy job ...
Just look for information about Pulse Wide Modulation (PWM = output RC controller) and transistors (amplifier for power).
Sry for my bad English....
Soundshock 10 years ago
Soundshock 10 years ago
Please tell me, I was trying to build one but I lacked power (rc airplane).
I forgive you for your bad english. :p
musicalgenius! 10 years ago
Does it fly well?
charles gray 10 years ago
ianmcmill 10 years ago
A video of this plane flying would be awesome !