Introduction: Mp5

By

this is the mp5 that i wasnt going to post but since so many people liked it i decided to post it.holds 16 shots and is quite powerful for a rubberband gun.

Step 1: Mechanism

1.build 2 of these
2. build these
3.slide in step 2 to step 1
4.add 2 red cogs with 2 blue spacers on each cog
5.add other step 1 to enclose mech
6. add 2 clips to make sure pin doesnt slide out
7.add blue rod here
8.make this
9.add a connector on each side
10.connect trigger

Step 2: Handle

1.make 2
2.add
3.add to top
4. add blue rod

Step 3: Shoulder Rest

1.make this
2.make this
3.make these
4.connect one of the step 3s to step 2 like this
5.do the same thing on this side
6.flip over and attatch blue clips
7.attatch together, should look like this

Step 4: Mag

1.make this
2.make this
3.make these
4.attatch step 3 to step 2 like this
5. add clips on blue rods
6.add step 1 like this and connect hinges
7. yay!

Step 5: Barrel

1.make this
2.make this
3.connect them
4.make this
5.connect step 3 to step 4 like this
6.swing hinges to here
7.slide in blue rod and add connectors on both sides so it doesn't fall out
8.done!

Step 6: Connect Them

1.connect mech and shoulder rest
2. like this
3.connect mech and handle
4.like this
5. connect barrel
6.like this(lol looks like a star wars blaster)
7.connect mag
8. done!

Step 7: Loading/firing

1.attatch rubberbands to trigger here 2 or 3
2.remove mag and hook rubberbands here(this will make trigger spring back when pulled on
3.reattatch mag
4.(no picture phone out of batteries)load rubberbands from front cog all the way to tip of gun in the tiny slot, continue to add rubberbands