Phone Charger Wall Hanger

Introduction: Phone Charger Wall Hanger

About: mechanical engeneering student

in this instructable i show you a wall hanger that i made in 123d design in which you can lay daown your phone while charging it, no more hanging phones, broken cables, or lost phones anymore. you don`t have to charge your phone near a table or chair anymore, only at a wall plug

Step 1: The Hanger

The hanger consists of:
-a hanger this is the loopy thing, you place this around the charger
-a small container to put your phone in while charging it
-a hole to put your cable through
-2 wall point so the hanger doesn`t wobble

Step 2: Colour

If you are going to print it, you can chose any color you want!

Autodesk 123D Design Challenge

Participated in the
Autodesk 123D Design Challenge

Be the First to Share

    Recommendations

    • Plywood Challenge

      Plywood Challenge
    • Plastic Contest

      Plastic Contest
    • Battery Powered Contest

      Battery Powered Contest

    Discussions