Introduction: Pico Gun Shotgun Mode

fires good but i have some problems with the hammer





sugestions are welcome

Step 1: Time to Assemble the Parts

the parts
14 grey connectors
5 red connectors
10 orange connectors

1 grey rod
1 red rod
6 blue rods ( for the handle ,its not required )

2 rubber bands or one veeeery big one

i am using green rods for the shotgun effect,but you can do it with really all rods exept the bendable rods

Step 2: Making Primary Parts

1.first put the orange connectors and the blue rods together
2.make the hammer
3. sorry for the picture but its just the 5 red connectors with green rods on a blue rod simple

Step 3: Put It Together !

it should work with just watching if not send me a mail or a comment and i will try to help

Step 4: Adding Rubber Bands

to begin put the rubber bands together as shown with the parts then
strap it through the grey connector and over the orange connector

Step 5: Firing

draw the hammer backwards and make shure the rubber band draws the red connectors to the side , put 5 green rods in the hole shown on the picture now pul the red connectors back from wher they came and of the bullet(s) go

The Instructables Book Contest

Participated in the
The Instructables Book Contest