Introduction: Powerful Blow Gun
Powerful blow gun that shoots darts into trees.
WARNING IF SHOOT AT ANYTHING THAT CAN BREATHE CAN CAUSE SERIOUS INJURY! I AM NOT RESPONSIBLE FOR ANY ACTIONS INVOLVING THIS GUN!
Step 1: Materials
you need:
tape
hot glue
nails
2ft of half inch pvc pipe
magazine sheet
scissors
Step 2: Cut the Page
Cut the page in half then into thirds.
Step 3: Tape
Grab one of the pieces u cut and three pieces of tape.
Step 4: Roll the Paper
Roll the paper so it is a tight cone.
Step 5: Add Tape
Add two pieces of tape so the cone keeps it's shape.
Step 6: Add the Nail
Push the nail through the back so it sticks out the front.
Step 7: Cut It
Slide the dart into your pvc so it has a tight seal, then cut it.
Step 8: Hot Glue
Fill the dart with hot glue. Make sure there are no air bubbles. Then let it dry.
Step 9: Fire
Put the dart on the side where u will blow. Then blow!