Introduction: Pump-action Knex Gun
This is a pretty basic knex gun with a new magazine. It has ok power - I got it to shoot 30 feet with one rubberband. This is my first instructable, so please go easy. Enjoy!
Step 1: The Body
This is the body of the gun. That's 28 spacers in the middle there.
Step 2: The Pump/ramrod
This is the ramrod and pump of the gun. Make sure that the yellow rod slides freely on the orange connector.
Step 3: The Magazine
This is the magazine of the gun. Yes, you have to decapitate two white rods to make it.
Step 4: The Handle
This is the handle of the gun
1. Make these
2. Make these
Step 5: Putting It All Together!!!
Now it is time to put the gun together!
1. Put the ram on the body
2. Put the handle and six spacers on the body
4. Add magazine
5. Finish mag
Step 6: Loading and Firing
Load four blue rods into the magazine of the gun. Pump the gun, pulling back the ram and pop the block into place. Pull the trigger at the side of the gun to fire! Look at pics for rubberband placement, though you could pretty much put the rubberbands anywhere.