Shower Stall Remove and Replace 1 of 7

by plumberx

2.1K42

Intro: Shower Stall Remove and Replace 1 of 7

Remove old shower stall and install new shower stall. Cut water to house off or if there are cut off behind the tub cut it off there. Carefully remove the old tub and shower valve. Remove handle, and esuction plate. Cut old valve out from the back side wall Clean work area and begin prepping the new tub and shower valve for installation. Begin install putting the new tub and shower in place and solder together , then come back to the tub side of the faucet in install the tub a shower trim.

2 Comments

docrings 12 years ago

Agreed.... make this ONE instructable, please. Unless you want to selfishly hog the "related" column with only your own instructables... But I doubt that was your reason..

Better to put each video on page 2, page 3, etc.

Awesome-aniac 14 years ago

No, no, no.  Why would you not just make one instructable?