Introduction: Super Cool High Power Knex Hand Gun
Small,high power,super cool,knex gun.Not the most accurate thing in the world,but powerful for its size.It is my second instructable.It uses very little pieces and not to hard to make ether.It shoots red connectors the best but can shoot any rods with a red connector on the end.(the smaller the rod the better). it takes under 5 seconds to reload and fire.LETS START BUILDING!!!!!!!!!!!!!!!!!!!!!
Attachments
Step 1: The Barrel
pic1:Make this 2Xs
pic2:add white connectors on one side only.
pic3:Make this
pic4:Put it on the white connectors
pic5:put the other side on but don't put the handle(the bit we haven't made yet)or the rubber band.
Step 2: The Handle
pic1:make this 2Xs
pic2:attach them on to the barrel.
Step 3: The Trigger
pic1:Make this
pic2:make this.
pic3:clip the white rod into the green rod.
pic4:put the stopper thingey BEHIND THE TRIGGER.(Very important that you put it behind the trigger)
Step 4: Rubber Bands and Firing
pic1:ammo
pic2:put rubber band on the end of the barrel,then clip a white connector over it (this does no interfere with firing).
pic3:put rubber band on the trigger and put ammo in the barrel.I prefer my ammo right by the trigger where the orange connectors stop.