Introduction: Tech Deck [paper]
how to make a paper tech deck
you will need :
a strip of paper or thin cardboard
tape
easier to do tricks than on a regular finger board,
if it gets taken at school it doesn't matter,
and its almost free!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Step 1: Fold It
fold it into a strip about the size of your thumb [not in thickness of course]
i zoomed in a lot so it looks smaller in the picture.
Step 2: Tape It Up
wrap tape around the whole thing!!!!!
Step 3: More Folding!
fold up the ends to finish your board.
have fun!
14 Comments
14 years ago on Introduction
i might rip the bottom of hot weels car and stick it on the bottom
Reply 10 years ago on Introduction
cool ones huh
i did it too, thanks for it
10 years ago on Introduction
nice job! i made ones for school so that i can make one if i lost em
12 years ago on Introduction
nice job! it looks like a surfboard and a snowboard and i made it with plastic and used it on water! its wonderful!
14 years ago on Step 2
ok it doenst look like a tech deck :|
Reply 12 years ago on Step 2
but its still cool!
13 years ago on Step 3
mine was alrite 3.5 stars
14 years ago on Step 3
dude my deck sux like yours sorry
14 years ago on Introduction
wut is it?????????????
15 years ago on Introduction
dumb nugget. this has already been done, they dont work very well, and the tech deck fad is over.
Reply 14 years ago on Introduction
tech deck is not a fad okay it is a little hobbie ot do
Reply 15 years ago on Introduction
for you mabye...
15 years ago on Step 1
It looks good but when you make it it is crap?
Reply 15 years ago on Introduction
yes