Flyback driver from monitor circuitry? Answered
So i've been into hv stuff for years,currently engineering undergraduate, just never did anything practical. So recently we got a new microwave, therefore old microwave= junkyard ^_^. Anyway, i acquired a MOT i also took the capacitor and diode, and the magnetron (never know when you could crave instant cooked meat ^_^ kidding).
Then a few days later (last week) someone left a computer monitor outside on the sidewalk, which equals source of flyback ^_^. clearly someone up there wants me to play around with hv (or is it someone down there..?) and so thats how i came into possession of a flyback. i could have had one a while back, we had a big tv, which had one of the big old flybacks which are way better than modern ones, but this is before i knew about flybacks and so i dismissed it as some large junk...to this day im still slapping my forehead over the fact that i let that go...
Naturally, i have a few questions:
1. I hooked up the mot to mains (deadly i know) but the arcs were insane. i tried ballasting it with a cfl bulb, 15 watts, however, when connected the mot did nothing. touching the hv to ground only made the cfl brighter. why?
2. i pulled the flyback with the circuit, i actually took out the whole board from the computer monitor. how can i use this as a driver? i know i could pull components out and make one but seems to me whats already there would be good enough.
3. Found out i can use a cfl to drive the flyback, can i also use this for the mot?
one other thing, i was thinking of using the mains transformer (torriodal transformer) from the monitor to power the mot and/or flyback, using it as a step-up or step-down transformer. Is this possible with the flyback?
Thanks, and sorry for the loong question im just excited ^_^