81Views4Replies

Author Options:

How to wire a switch Answered

Hi I would like to know how this switch should be wired up. I am using it on a drill press. It has 2 relays 1/ nc zb2-be102 2/ no zb2-be101. Any help would be much appreciated. Thanks ratjack

Discussions

0
None
caitlinsdad

2 years ago

Are you upgrading the safety/on-off switch on your drill press or you want to add a remote switch for it? The specs on the zb2-be101 zb2-be102 say they are industrial mains use switches - pushbutton one normally closed, the other normally open. I do not know if the unit you have will physically eject one button when the other is pressed or if they are just two independent pushbuttons. That is where you have to know about the drill press electronics in order to wire up the control switches. What kind of motor controller is on there? So I think you will have to see how the drill press is wired and if you can incorporate these switches. Good luck..

0
None
Toga_Dan

2 years ago

I'll try to help when I get over to a real computer.

0
None
Downunder35m

2 years ago

Sorry but I don't see why anyone would download a 9mb zip file and risk infecting his computer for this.

0
None
FrancoisH2

2 years ago

Have you received any feedback on this? I am also looking for the soloution. Thanks