Schematic needed for square wave generator. Answered
I need a schematic and the code for a square wave generator, with the following specs (although it is a bit specific)
Repition Rate (external trigger, 20 Hz 200 Hz 2KHz 20 KHz 2 Mhz and 5 MHz) controlled by a rotory switch.
a vernier (pot) controlling pulses per second.)
a single shot button (N.O. push button)
external trigger (BNC Connector)
Delay (Rotary Switch) .1, 1, 10, 100, 1k, and 10k microseconds
Vernier (pot) for the delay
a sync output (BNC Connector) with a toggle switch for polarity.
double or single pulse on the output (toggle switch)
polarity selection on the output (toggle switch)
gate on off (BNC connector and toggle switch)
10db step (on or off toggle)
50 ohm load on or off (toggle switch)
rise and fall time (pot)
Any help would be greatly appreciated, as this is a bit specific. I only need a schematic, and everything else i can take care of.
Once again, Thanks for the help.