203Views6Replies

Author Options:

can i attach .8mm bit on power drill? Answered

i have a power drill of chuck size 1.5mm can i attach .8 mm bit on that help me

Discussions

0
None
rickharris

6 years ago

If you mean HOW can you use a small bit in a power drill then your bet bet is to buy a PIN vice These will hold the drill and have a larger shank that will go in the power drill

HOWEVER drilling with a very small bit by hand is very hard as the drill wobbles and you break the bit. It is better to use a drill stand if possible.

0
None
lemonie

6 years ago

If you don't need a lot of torque (i.e. you're drilling something soft, thin, gently) wrap tape around the thing.

L

0
None
steveastrouk

6 years ago

I hope this isn't a carbide drill, because it will snap a fraction of a second after you touch the job with it.

0
None
AndyGadget

6 years ago

 
The answers below are the proper way to do it, but for a quick and nasty solution, shrink a piece of small diameter heat-shrink tubing onto the shank of the bit.  If that doesn't increase the diameter enough then shrink another piece over that.  Don't go mad though - Every layer will increase the bit's tendency to wander.

0
None
canucksgirl

6 years ago

You can buy adapters for your drill to allow you to use smaller bit sizes. They are commonly used for drilling PCB's. Here's a company that sells them and ships worldwide, but you can also check stores closer to where you live.