112Views10Replies

Author Options:

does my circuit need any resistors? Is the capacitor needed ? Answered

Discussions

0
None
steveastrouk

1 year ago

Yes, Nice fat 100uF where the power enters your board, with a 100nF ceramic across that, also 100nF on the output of your voltage regulator

0
None
drystreamssteveastrouk

Answer 1 year ago

Thank you! I understand you suggest I put one on the input of the board and on the output of the voltage regulator. What does "with a 100nF ceramic across that" mean? Not being sarcastic but I want to make sure I understand what you mean. Thank you.

0
None
drystreams

1 year ago

mistake on diagram. how it really is

IMG_9418.jpg
0
None
drystreams

1 year ago

The blue wire is what triggers the relay from NO to NC. The regulator is an NTE960. I have not had any issues (running for 3 days) with not enough power or regulated power. I will incorporate. Made a mistake on the diagram. Here is how it really is...

0
None
iceng

1 year ago

By all means daystreams your ecoli incubator circuit aha is here

https://www.instructables.com/community/TE9RPH4JAV...

I do not understand the blue wire to the relay which needs a reactive diode across the coil.. Excluding the heater & relay, each component that uses power needs a filter cap 4.7uF tantalum or electrolytic and a 0.1uF disc or mylar as close as possible.. Especially both sides of the regulator..

0
None
rickharris

1 year ago

More than likely.

Needs more polishing ICENG.

ball.jpg
0
None
icengrickharris

Answer 1 year ago

+1

This occurs when there is no corresponding image supplied daystreams.