Wooden Sword

Introduction: Wooden Sword

this is a super easy sword to make. all you need is a dowel rod, a screw, a knife(optional), and a drill. first, cut the dowel to the length you want. then mark where handle ends. optional, to make the drilling easier cut out a groove where the cross piece will be. finally, use the extra dowel to be the cross piece by screwing it on the sword in the groove. this can be used as a prop our for battling, but don't hurt people with it. 

Supplies

Hack It! Contest

Participated in the
Hack It! Contest

Halloween Photo Instructable Contest

Participated in the
Halloween Photo Instructable Contest

Halloween Props  Contest

Participated in the
Halloween Props Contest

Be the First to Share

    Recommendations

    • Toys & Games Contest

      Toys & Games Contest
    • Furniture Contest

      Furniture Contest
    • Big vs Small Challenge

      Big vs Small Challenge

    3 Comments

    0
    Mr. tony stark
    Mr. tony stark

    Reply 8 years ago on Introduction

    it weighs about a pound and it is not balanced but if you use it with two hands it should be ok.

    0
    star-lord6
    star-lord6

    Reply 9 months ago

    or, you could also use a dowel cross piece on both sides, then use another dowel of the same with as the blade, then cut int in half, then nail it in between the two dowels on the sides to make a bigger guard and balanced. and, if you really wanted to do more, you could then cut a angle in the dowel in the middle of the two dowels on the sides, then nail them in slanted up or down, with the angle you just cut up against the blade. that would be cool.