X1000 Avenger Sniper Rifle V1

Introduction: X1000 Avenger Sniper Rifle V1

About: none of your business

this instructable shows you how to make my x1000 avenger sniper rifle v1 its a sling shot with a new trigger system it gets about 130 feet of range.

Step 1: Ammunition

this step shows how to make the ammunition.

Step 2: Barrel

this step shows how to make the barrel.

Step 3: Barrel Support

this step shows how to make the barrel support so it wont snap.

Step 4: Trigger

this step shows how to make the trigger and connect it to the barrel.

Step 5: Stock/handle

this step shows how to make the stock/handle.

Step 6: Rubber Band Catcher

this step shows how to make the rubber band catcher.

Step 7: Rubberbands and Rubber Band Mounting

this step shows the rubber bands and rubber band mounting.

Step 8: Loading and Cocking

this step shows how to load and cock my gun.

Step 9: Warning!

do not use more the one rubberband on this gun it will break the trigger.p.s have fun shooting!

Be the First to Share

    Recommendations

    • Holiday Decorations Speed Challenge

      Holiday Decorations Speed Challenge
    • Plywood Challenge

      Plywood Challenge
    • Battery Powered Contest

      Battery Powered Contest

    91 Discussions

    0
    knexrule2012
    knexrule2012

    8 years ago on Introduction

    hey, can i possibly use this mech in one of my future guns???

    0
    STUNTMANIC101
    STUNTMANIC101

    Reply 9 years ago on Step 2

    Thanks I can final start building this thing

    0
    STUNTMANIC101
    STUNTMANIC101

    9 years ago on Step 9

    Not true I have three and two are really strong bands

    0
    Knex_Gun_Builder
    Knex_Gun_Builder

    Reply 9 years ago on Step 9

    Just a safety precaution, Don't want anyone getting hurt. Mine could only take one #64.

    0
    slimshaddy
    slimshaddy

    9 years ago on Introduction

    what are some pieces that i can substitute because i only have 26 yellow connectors and 13 orange connectors.

    0
    Knex_Gun_Builder
    Knex_Gun_Builder

    Reply 9 years ago on Introduction

    the handle and the stock don't have to be made either, and I suppose you could skeletonize the barrel

    0
    Knex_Gun_Builder
    Knex_Gun_Builder

    Reply 9 years ago on Introduction

    You don't have to put the orange connectors on the bottom of the barrel, BUT YOU MUST PUT BLUE RODS IN THEIR PLACE!