I created this for use in library period at school as reading books non-stop for an hour gets boring very quickly..... therefore a means to start making.

Can be easily adapted for other ipods/MP4s.

Step 1: What You Need

For this instructable your going to need:
A craft knife.
an old book
an ipod
some cardboard
and glue.

Step 2: Step 1: Mark Out Ipod.

mark around your ipod getting ready to cut out a hole for your ipod to sit in.

Step 3: Step 2:cutting Holes in the Pages

Now to cut out the holes in the pages for were your ipod is going to sit. make sure you make deep enough to fit your ipod in so the cover can fit over it.

Step 4: Step 3: Making a Cover Part 1

From here onwards is optional and is not needed. I just did this next part because im a bit of a perfectionist.

Cut out a piece of cardboard about a centremetre in from all four sides of the page. This allows the page to still turn over like a normal page.

Step 5: Step 4: Making a Cover Part 2

Now, glue down the cardboard between two pages just above all the pages you've cut a hole in to house the ipod.

Step 6: Final Step

Now mark out where your screen and clickwheel would be when the ipod is in its housing. After marking, cut out the holes in the cover for the clickwheel and screen.