Introduction: 360 Degree Panning Tripod Mount
360 Degree Panning Time-Lapse Tripod mount is built from a simple kitchen timer, 3/8" long 1/4"-20 bolt, and a matching 1/4"-20 nut. All can be found at your local store for less than $8. First disassemble the kitchen time removing the other white plastic, and timer face plate. Then use a dremel to remove the top post which connected to the timer face plate. This will give you a flush surface to mount your 3/8" 1/4" bolt which will eventually screw into your camera. Glue in place using hot glue or some sort of epoxy for a better hold. Then glue or JB weld on the nut onto the bottom of the metal casing of the timer. This is where your tripod will screw into.
Participated in the
Make It Move Challenge