Introduction: Arduino - FLOOD ALARM - Using a Simple Water Level Sensor

Picture of Arduino - FLOOD ALARM - Using a Simple Water Level Sensor

Hello world! Today i made a simple flood alarm with a water level sensor. I do not sell these sensors on my website because they don't last very long when measuring water i will order gold coated ones and test them for a few weeks, but its very simple to build and useful for a flood alarm, beside that the sensor is very cheap. I'm sure this is useful for some. Follow the next step for the Schematic Code & Parts list.

Step 1: Schematic Code & Parts List.

Picture of Schematic Code & Parts List.

Just wire it up like the schematic, upload the code and it should work.

Parts list.

  1. Arduino uno, I used the RobotDyn uno.
  2. Water level sensor.
  3. Buzzer.
  4. Led ( i used white)
  5. Jumper wire set MM/FF/FM

Good luck!

Comments

DaveP148 (author)2017-09-03

Is it possible to use any kind of microcontroller here? Like arduino uno or nano.

vandenbrande (author)2016-05-09

Follow me for more! I will share many projects!

AhmadS33 (author)vandenbrande2016-11-06

awesome project

qrko (author)2016-07-06

You linked analog sensor and connected it to digital input. Is that correct?

About This Instructable

4,904views

9favorites

License:

Bio: Hello world! I make simple & Advanced projects for people who want to learn programming and electronics. Most of my Instructables are about arduino and the ... More »
More by vandenbrande:ARDUINO - SOLID STATE RELAY FAN/ventilator Control Using the W1209 Thermistor and SSR-25 DA Arduino - SSR-25 DA Solid State Relay and DS3231 RTC Automatic Timer Lamp Arduino & C# - RGB LED / LED STRIP CONTROL C# Application
Add instructable to: