Introduction: Illuminated Clock Using a Scroll Saw
A very cool light up clock made by using a Scroll Saw.
Step 1: Materials/Tools
1 analog clock
1 large piece of plywood
Spray adhesive glue
Pencil
Scroll Saw or try the Dremel Trio
Styrofoam
Hot glue
Drill
Movable lamp
Step 2: Trace
Trace the outside of the clock on thin plywood.
Step 3: Cut
Cut with a scroll saw the outside of the clock.
Step 4: Glue
Use spray adhesive glue ( do not put too much on because you want to be able to take this off after if you put too much on wait a bit for some of it to dray and attach to the round piece of wood).
Step 5: Drilling and Cutting
Drill a hole at the end of each number. Put the round saw in through each hole and cut it out.
Step 6: Attach to Light
Put it all together with the clock movment the clear plastic piece and the frame.
Step 7: Your Done Have Fun!
Participated in the
ShopBot Challenge
Participated in the
Make It Glow Challenge
Participated in the
Holiday Gifts Challenge