Introduction: Loom Skeleton Hand
Okay, I know Halloween isn't for a while, but I couldn't wait to post this! It's a super cool skeleton hand that can be worn on any occasion! Okay, maybe not=)
Step 1: Gather Supplies
Let's gather the supplies...
Skeleton Hand:
•Lots of Rubber Bands
•1 s-clip or c-clip
•Moveable Loom (Or a normal one, I guess)
•Optional: 25 Beads
Step 2: Take Two (2) Bands
Step 3: Put It On
Place these double bands in the left side of your loom.
Step 4: Take Two More
Step 5: Bead It
Place the two beads through the bead.
Step 6: Then Put It on Your Loom
Step 7: Skip and Repeat
Place double bands on the loom and loop another bead. Repeat this process until you reach your desired length.
Step 8:
Step 9:
Step 10:
Step 11: Cap Band
Place a cap band onto the last peg and wrap it around that peg twice.
Step 12: Twist
Step 13: Place
Step 14: I'm Going In!
Go into your cap band and grab the two rubber bands that will go forward.
Step 15: Like This
Step 16: Repeat
Loom as if it were a triple single all the way.
Step 17: Remove
Step 18: First Finger Done
Now your first finger is done. Repeat the finger making process until you have five fingers. Lengths may vary.
Step 19: Off to the Side
Put your finger onto a long, slim object for later.
Step 20:
Step 21: Second Finger Done
Step 22:
Step 23: Third...
Step 24:
Step 25: Fourth...
Step 26:
Step 27: And Fifth
Step 28: Only Movables?
I made mine on a rainbow loom, but it is possible to do this next part on any loom.=) When you have loomed half of the bracelet part, remove from the loom and place it to the side. Make another half. Before looming the second half, place the first half at the end and loom like normal.
Step 29: For Movables...
Take your loom apart and take two rows. Place them end to end on a sturdy surface.
Step 30: Place a Single Band
Step 31: Go Down 3 More Times
Step 32: Place a Single Band Through the End
Step 33: Place on Loom As Shown
Step 34: Down Four
Step 35: Place Another Finger
Step 36: Down Four...
Step 37: Another Finger
Step 38: Down Four and Another Finger
Step 39: Down Four and the Last Finger
Step 40: Another Cap Band
Add a cap band to the end and wrap around twice.
Step 41: Twist
Step 42: Place
Step 43: Go Into the Cap Band
Step 44: Bring the Band at the Bottom Forward
Step 45: Loom Like Normal All the Way Down
Step 46: Add Clip
Step 47: Remove
Step 48: Attach
Step 49: Place Around Your Wrist
Yes, this will be very loose, but it's for a reason=)
Step 50: Onto the Thumb
Put the end of the first finger onto your thumb.
Step 51: Repeat
Repeat this on all fingers.
Step 52: Boo! XD
Did I scare you? No? Oh=( Thanks so much! Hope you enjoy your spooky new "glove"! =P