Ten Minute Bazooka

Ten minute bazooka 

What you need: 3/4" pvc pipe, pvc cap to fit the pipe, rubber mallet, Co2 cartridge (the kind for soda siphons), screwdriver, drill, drill bits, Dremel

Step 1: Step 1

Ten minute bazooka

What you need: 3/4" pvc pipe, pvc cap to fit the pipe, rubber mallet, Co2 cartridge (the kind for soda siphons), screwdriver, drill, drill bits, Dremel 

Step 2: Step 2

You will need the pipe and pvc glue

Glue the cap to the end of the pipe.

Step 3: Step 3

Tap the cap on to the pipe. Let it dry, then drill a hole smaller than the screw.

Step 4:

Use the drill or screwdriver and screw the screw into the small hole.

Step 5:

Slide the inner tube over the pipe and tape the inner tube with duct tape. You can tape one of your old belts to the pipe for a shoulder strap.

Step 6:

WARNING DO NOT POINT AT ANY ONE  have fun