Tell us about yourself!
I made it myself u can try a 5 mm 5 mm coupler
I made it special thanks to vulcaman
Hi etetan I have the same problem as you had could you tell me how u solved it ? the motors are not moving in any axis I checked the connection thermistors baud rate 115200 decreased the steps per mm but the motor is not moving
How to Accurately Calibrate Your 3D Printer
I have the same problem Ethan I uploaded the firmware but eprom is grayed in repetier the motors are not moving the extruder is connected as well as the thermistor
50th Birthday Cake
Hi vulcaman could you share the design i kind of neeed it for my project
3d scan anything using just a camera
DIY 3D Printer Enclosure
Hey could share the blind joint details I couldn't find them anywhere my thingiverse I'd is if same name
what are the psu for 600 w heated bed?
does the nema 17 motor have to be bipolar? or is there any specifications needed?
what is that material it doesn't look like ABS?
Hi I am using the silicone heating pad 600 w it is 24 v how much watt power supply should I use? The 1000 w is really hard to find and very expensive.
Could you me send me too?