loading
3Comments

Tell us about yourself!

Complete Your Profile
  • Make Your Own Electric Motorized Longboard

    I'm currently working on the nunchuk controller but have some questions because my board looks different. Where should I be soldering the wires for the analog stick? I know the 3 pins on the left are for the 2 buttons but I'm unsure about the rest. The nunchuk uses I2C to communicate. Why didn't you just attacb the transmitter + battery to the nunchuk and then have the arduino on your longboard translate the I2C to the ESC? Also if I wanted to use this: http://www.amazon.com/Addicore-nRF24L01-Transceive...for communicating instead I would need and 2 arduinos? Would you recommend?

    Picture is of nunchuk electronics*

    View Instructable »