DeathBlade
- Date Joined:Sep 28, 2006
- Instructables:4
- Total Views:119,164
- Featured %:50%
- Subscribers:22
- Comments:11
Instructables 
Patches
DeathBlade has not received any patches yet... send DeathBlade a patch!
Comments
» I've seen the premade welder setups before, I'm uncle had a Premier Power welder setup …
» Propane tanks are rated to 200psi so 120 from the compressor is just fine, as for the s…
» Someone really must not know about diesel engines or fuel for that matter. Diesel just …
» A coaxials chamber and barrel are also in the same axis to that is also a workable defi…
» It could be 'coaxial' in the way that is similar to coaxial cable, a conductor(barrel)i…
» I know I always mix those up, kind of how I sometimes call my garage a refrigerator.
» By drilling one or two small holes in the edge of the piston, or if the piston is loose…
» The cost of a refill for my tank on my mig is $7 USD and that is a 20 pound tank, this …
» If it is the small cheap type of compressor(the ones that plug into cigarette lighters)…
» I think the pressure of the gaseous co2 is 800 PSI with liquid Co2 in the bottom, but …
» Propane tanks are rated to 200psi so 120 from the compressor is just fine, as for the s…
» Someone really must not know about diesel engines or fuel for that matter. Diesel just …
» A coaxials chamber and barrel are also in the same axis to that is also a workable defi…
» It could be 'coaxial' in the way that is similar to coaxial cable, a conductor(barrel)i…
» I know I always mix those up, kind of how I sometimes call my garage a refrigerator.
» By drilling one or two small holes in the edge of the piston, or if the piston is loose…
» The cost of a refill for my tank on my mig is $7 USD and that is a 20 pound tank, this …
» If it is the small cheap type of compressor(the ones that plug into cigarette lighters)…
» I think the pressure of the gaseous co2 is 800 PSI with liquid Co2 in the bottom, but …
Groups
Orangeboard
2
comments
|
Add Comment
|
Thanks for sharing your project, and welcome to Instructables!
Let me know if you have any questions.
You've probably already found your way around, but in case you haven't see these, here's a guided tour of Instructables and an Instructable for making Instructables.
Let me know if you have any questions.
You've probably already found your way around, but in case you haven't see these, here's a guided tour of Instructables and an Instructable for making Instructables.
i have a couple of compressors that have 2 outlets one high one low witch do you use?
 |
