PaulE
- Date Joined:Dec 21, 2005
- Instructables:3
- Total Views:200,777
- Featured %:33%
- Subscribers:5
- Comments:25
Instructables 
Patches
PaulE has not received any patches yet... send PaulE a patch!
Comments 1-10 of 25(view all)
» I think it should work ok. Just pull very hard and go slow. You keep the conduit very…
» My particular (I'd assume most) when in NMEA mode continuously send position data over …
» One of my friends places his other junk mail in the envelopes (junk mail swap). He says…
» We used to have a version of this in the army. The quickest way to get started is going…
» Not sure. I used 3/4 inch tubing. I would guess that as long as the jig is bigger that …
» Here's something else for your model planes. Epoxy doesn't stick well to HDPE. So, if …
» no heat gun, try this: seal the plastic to the system, crank on the vacuum and place a…
» A easy way to pre-shrink soda bottles (in my experience) is to fill them with boiling w…
» good idea. When its not winter (or if you're in Florida like me) I bet you could dump s…
» Just curious, how are you getting work from the engine? Or is is designed fro thrust i…
» My particular (I'd assume most) when in NMEA mode continuously send position data over …
» One of my friends places his other junk mail in the envelopes (junk mail swap). He says…
» We used to have a version of this in the army. The quickest way to get started is going…
» Not sure. I used 3/4 inch tubing. I would guess that as long as the jig is bigger that …
» Here's something else for your model planes. Epoxy doesn't stick well to HDPE. So, if …
» no heat gun, try this: seal the plastic to the system, crank on the vacuum and place a…
» A easy way to pre-shrink soda bottles (in my experience) is to fill them with boiling w…
» good idea. When its not winter (or if you're in Florida like me) I bet you could dump s…
» Just curious, how are you getting work from the engine? Or is is designed fro thrust i…
