loading
5Comments

Tell us about yourself!

Complete Your Profile
  • Make your weighing scale hack using arduino and hx711

    I found this link useful: http://electronics.stackexchange.com/questions/199487/connect-hx711-to-a-three-wire-load-cell

    View Instructable »
  • Make your weighing scale hack using arduino and hx711

    The HX711 has pins for 2 load cell sensors. Please explains specifically which wires: Red(Signal) , Black (Positive-Vss), and White(Negative-Vcc) from the load sensors connect to which pins on the chip (E+, E-, A-, A+,B-, B+). Example Solution: Sensor 1: Black1 to E+, White1 to E-, and Red1 to A-. Sensor 2: Black2 to A+, White2 to B-, and Red2 to B+. Please advise.

    can you clarify how to connect the wires to the chip? see above post

    The HX711 has pins for 2 load cell sensors. Please explains specifically which wires: Red(Signal) , Black (Positive-Vss), and White(Negative-Vcc) from the load sensors connect to which pins on the chip (E+, E-, A-, A+,B-, B+). Example Solution: Sensor 1: Black1 to E+, White1 to E-, and Red1 to A-. Sensor 2: Black2 to A+, White2 to B-, and Red2 to B+. Please advise.

    The HX711 has pins for 2 load cell sensors. Please explains specifically which wires: Red(Signal) , Black (Positive-Vss), and White(Negative-Vcc) from the load sensors connect to which pins on the chip (E+, E-, A-, A+,B-, B+). Example Solution: Sensor 1: Black1 to E+, White1 to E-, and Red1 to A-. Sensor 2: Black2 to A+, White2 to B-, and Red2 to B+. Please advise. I have actually have 4 such sensors, but would like to only configure 2 for my project.

    View Instructable »
  • ShaneH26 followed Science, Life Hacks, Robots, Electronics and 6 others channel 11 months ago