loading
3
19 Comments

Tell us about yourself!

Complete Your Profile
  • Xalax followed RaviP61 month ago
  • Xalax commented on Elektron8's instructable 3D Printed Desktop CNC mill1 month ago
    3D Printed Desktop CNC mill

    Hi Kevin, you can download the firmware from the link above. But I couldn't make it works...

    View Instructable »
  • Xalax followed Elektron86 months ago
  • Xalax commented on Elektron8's instructable 3D Printed Desktop CNC mill6 months ago
    3D Printed Desktop CNC mill

    Hi,The CNC is built, all axis goes to zero when it's switched to ON and I can move all axis by the joystick. The communication between the CNC and the Hyper Terminal is established via the Arduino's USB connector. I still don't have communication with the SD-card reading neither to the CNCSimulator software.Any suggestions on how to send a g-code to the machine?And why the SD-card is not responding?

    Hi,The CNC is build, all axis goes to zero when it's switched to ON and I can move all axis by the joystick. The communication between the CNC and the Hyper Terminal is established via the Arduino's USB connector. I still don't have communication with the SD-card reading neither to the CNCSimulator software.Any suggestions on how to send a g-code to the machine?And why the SD-card is not responding?

    View Instructable »
  • Xalax commented on Elektron8's instructable 3D Printed Desktop CNC mill6 months ago
    3D Printed Desktop CNC mill

    I connected it to the RESET of the Arduino. Maybe it's not the right way, but it works. It's a good idea to use an ON/OFF switch too.

    View Instructable »