loading
3Instructables261,521Views45Comments
Just a guy really. Like building stuff and like to help other people build stuff too. If you really need to know, am male in my 30's and live close to Brisbane in Queensland, Australia.

Tell us about yourself!

Complete Your Profile

Achievements

10K+ Views Earned a bronze medal
Contest Winner Runner Up in the Game.Life 3 Contest
Contest Finalist Runner up in the Hurricane Lasers Contest
Contest Winner Runner Up in the Epilog Challenge V
Show 3 More »
  • The Etchinator - low cost PCB spray etcher (under $100)

    The size of the PVC is not that critical. You can get by with anything in the approximate range. Thin wall is slightly better as it will need less unblocking with heavy use.The impellers NEED a hole in the middle rather than at the edge. You need that lip on the edge to stop the fluid being flung back out when centripetal force is pushing the fluid to the outside of the tube.

    Bungard sell a smallish spray etcher for a few $K

    View Instructable »