greyhathacker45
- Date Joined:Jul 7, 2007
- Instructables:2
- Total Views:166,259
- Featured %:100%
- Subscribers:25
- Comments:16
Instructables 
Patches
greyhathacker45 has not received any patches yet... send greyhathacker45 a patch!
Comments 1-10 of 16(view all)
» All of those materials are fairly porous, and thus will soak up the potent die present …
» I wouldn't. This schematic is more complicated that the setup that you need for a hot …
» I explain the fact that using a higher input voltage won't allow you to go as low in te…
» I toasted a roll of film one time with the glow from my watch. It doesn't take much li…
» NH-5 is a rapid fixer without hardener. According to the instructions, 30 seconds is s…
» That's a crap-ton of batteries...
» Eagle... there's a new version out. Get it from their website.
» The piezo should have a side that is brass. Attach the foam tape to this side. the f…
» WHY DO PEOPLE ASK COMMENTS IN ALL CAPS? You've got to attach the piezo element INSID…
» You would need to build in the lm137, the negative version of the lm317.Datasheet: http…
» I wouldn't. This schematic is more complicated that the setup that you need for a hot …
» I explain the fact that using a higher input voltage won't allow you to go as low in te…
» I toasted a roll of film one time with the glow from my watch. It doesn't take much li…
» NH-5 is a rapid fixer without hardener. According to the instructions, 30 seconds is s…
» That's a crap-ton of batteries...
» Eagle... there's a new version out. Get it from their website.
» The piezo should have a side that is brass. Attach the foam tape to this side. the f…
» WHY DO PEOPLE ASK COMMENTS IN ALL CAPS? You've got to attach the piezo element INSID…
» You would need to build in the lm137, the negative version of the lm317.Datasheet: http…
Orangeboard
3
comments
|
Add Comment
|
Jan 9, 2010. 1:44 PMdmb10286
says:
Hey on your power supply you have on their I'm a little lost as to how to connect my potentiometer, it does have leads or pins to put through the perfboard but more 3 terminals with circles at the ends they dont fit through the holes....should I connect them via soldering a copper wire to the terminal and then through the hole??
Thanks for sharing your project, and welcome to Instructables!
Let me know if you have any questions.
You've probably already found your way around, but in case you haven't seen these, here's a guided tour of Instructables and an Instructable for making Instructables.
Let me know if you have any questions.
You've probably already found your way around, but in case you haven't seen these, here's a guided tour of Instructables and an Instructable for making Instructables.
 |
