With Instructables you can share what you make with the world, and tap into an ever-growing community of creative experts.
Hi zedonetx, My switches had only two posts (see photo in step 4), so all I had to do was stick one on each wire: Your key press is registered when you connect one specific solder point on the circuit board with another one. So a short wire soldered to those two points would always send that letter press, which is not very useful. So to get only one press, you cut that wire and stick one post of the switch to each cut end. That's all I've done here, except the wire is long enough to reach from the circuit board to the switch and back.Hope that helps. Cheers!Mike
Many thanks, Intofx!
"Get me out of here!" pumpk...View Instructable »
Hi IsaacC48, this looks a bit familiar...http://www.instructables.com/id/Skull-Pumpkin/
3D Printing Class
Nerd Throne: a Bog/Stargaze...View Instructable »
You'd cap it off at night. Cheers!
Super Basic Solar Lighting under $75
Folding Sewing Box - For Beginners
JURY DUTY: How to get your walking papers and other tips
EWaste 60$ 3DPrinter
Isolation transformer upgrade for old guitar amps
LED Chess Set
Join 2 million + to receive instant DIY inspiration in your inbox.
© 2016 Autodesk, Inc.