vectorges
- Date Joined:Dec 28, 2006
- Instructables:4
- Total Views:11,924
- Featured %:50%
- Subscribers:6
- Answers:2
- Topics:1
- Comments:25
Instructables 
Patches
vectorges has not received any patches yet... send vectorges a patch!
Questions
 |
Forum Topics
Comments 1-10 of 20(view all)
» Click on the blog in the second paragraph
» ANd if you used a slightly larger disk you could increase the differance. ANother grea…
» That sounds far too easy! You are probably right. The object is a varying radius surfac…
» 2. The clamps are uni-directional. They tighten as you push against them, but release i…
» Very well done. Is the kit (or at least the pcb available somewhere?
» If you are going to install the board semi-permanently the ft232 board (or equivalent) …
» I have been studying this for a couple of hours and have a few questions-1. There are t…
» Great instructable. I have an application to use a few Arduino's in permanent installat…
» I have converted two ATX supplies (successfully) to power lights in my kitchen. Now I h…
» This is great. I have one suggestion and one comment. Comment - I would like to see mor…
» ANd if you used a slightly larger disk you could increase the differance. ANother grea…
» That sounds far too easy! You are probably right. The object is a varying radius surfac…
» 2. The clamps are uni-directional. They tighten as you push against them, but release i…
» Very well done. Is the kit (or at least the pcb available somewhere?
» If you are going to install the board semi-permanently the ft232 board (or equivalent) …
» I have been studying this for a couple of hours and have a few questions-1. There are t…
» Great instructable. I have an application to use a few Arduino's in permanent installat…
» I have converted two ATX supplies (successfully) to power lights in my kitchen. Now I h…
» This is great. I have one suggestion and one comment. Comment - I would like to see mor…
