loading
3 Comments

Tell us about yourself!

Complete Your Profile
  • How to make a remote controlled Robotic Hand with Arduino

    yes, the test code for the glove works fine and gives good values but i dont get the same values when i run the test code for the robotic handactually the first two values are accurate sometimes but the remaining values are never correct

    actually i modified the glove code to print the angle values so what i see in the serial monitor are mapped angle values.

    View Instructable »
  • How to make a remote controlled Robotic Hand with Arduino

    hi.I am very close to completing this project. The readings on the hand are showing some issues. The PIinky finger readings show only either 0 or 180 irrespective of the position of the corresponding flex sensor. Also middle and annular values change simultaneously even though i m only bending my middle finger. however the test readings on the glove are perfectly fine. Where did i go wrong and how can i correct this?? Thanks in advance

    View Instructable »