Fast Hot Glue Mold for Small Things
Intro: Fast Hot Glue Mold for Small Things
Here I will show to you how to make a fast, simple and cheap hot glue mold to reproduce small things.
STEP 1: Materials
You will need:
1. Some oil
2. Hot glue gun
STEP 2: Preparing the Thing
The small thing that you want to make a mold must support a temperature about 100 degree Celsius, that is the hot glue temperature.
I choose a half-dollar coin, but you could choose anything else.
First put the object above a smooth surface. Then spray a little oil on it and spread it evenly with a piece of cotton. Spread a bit around too.
STEP 3: Making the Mold
Wait for the hot glue heats well and slowly apply it above and around the object. Use your hand to push the glue rod inside the gun, to help the flux exit evenly. Try to avoid make bubbles (sometimes is difficult).
STEP 4: Separating the Object
Wait until the glue cools well and carefully peel the mold out of the object.
Now you have a fine plastic mold with all the details of the object.
STEP 5: Reproducing the Object
Spread a little oil inside the mold.
Now fill the mold with the material of your choice. I choose epoxy, but you could use another material, like clay or acrylic resin.
STEP 6: Finalizing
Wait for the material to harden and carefully retires it.
Make the finishing, cut the scraps and paint it, if you want.
Have fun!
40 Comments
GerardD32 6 years ago
ArticAkita 8 years ago
SamanthaH2 9 years ago
can you use food? y'know like oreo cookies...
Datawolf 8 years ago
Oreo will not support 100°C.
To mold Oreos you can use Oogoo. (and it's even cheaper)
Georgemk 10 years ago
Unstoppablesonic 11 years ago
ilovegm 11 years ago
hot glue is cheaper though
imBobertRobert 12 years ago
dbrt60 12 years ago
imBobertRobert 12 years ago
iminthebathroom 12 years ago
kenobr100 13 years ago
Lindsley 13 years ago
LadyBoi 13 years ago
Lindsley 13 years ago
DogDynamo13 13 years ago
Lindsley 13 years ago
blackdragon27 13 years ago
Lindsley 13 years ago
blackdragon27 13 years ago